Slide-In Identification Strips For The Function Keys; Fig. 6-2: Identification Strip Set For Vcp 20; Fig. 6-3: Position Of The Identification Strips - Bosch Rexroth IndraControl VCP 20 Project Planning Manual

6-6 Bosch Rexroth AG | Electric Drives and Controls
Display and Operating Components

6.2.4.1 Slide-in Identification Strips for the Function Keys

The identifications strips can be replaced when the operating device is
removed. Inserting the strip from the rear side of the front plate does
not influence the specified seal of the operator terminal. A set of identi-
fication strips is supplied with the operator terminal.
For the labeling use:
Single pieces, prototypes
Small series
Large series
The set consists of
• two identification strips, labeled F1 to F12 and
• two unlabeled identification strips.

Fig. 6-2: Identification strip set for VCP 20

Fig. 6-3: Position of the identification strips

Rexroth IndraControl VCP 20 | R911299722 / 02
Label with a water-resistant pen
Copying foil with laser print
Customer-specific labeled identification
strips