Calibrating Gas Detectors - ExRobotics ExR-2 Operating Manual

9.6. Calibrating Gas Detectors

Gas detectors (if fitted) should be calibrate at the intervals specified by their manufacturers and in
accordance with their guidelines (Reference 7).
Gas detectors are located within a robot's hull. They're usually accessible by removing the top panel
of the hull, although in certain cases, it may also be necessary to remove the right hand side panel
and/or the back panel as described in Section 9.4. The orientation of the gas sensors may differ
depending on the additional options that have been installed. These pictures depict two examples.
ExRobotics B.V.
ExR-2 Robot
Operating Guide
This document is considered an uncontrolled copy when printed. Always ensure that you print and use a current version.
Copyright 2023 ExRobotics B.V.
Document No.: Owner:
20220412IP1
Version No.: 3 Ian Peerless
Date:
Page 46 of 69
2023-07-25