Plug-In Led And Valet/Program Switch; Bitwriter Interface - 3-Pin Black Plug - Directed Electronics Viper 5501 Installation Manual

Hide thumbs Also See for Viper 5501:

Table of Contents

Plug-in LED and valet/program switch

The LED and valet switch are incorporated into the control center the LED line

will plug into the white 2-pin port and the Valet switch line will plug into the blue

2-pin port.

Note

Onboard LED and valet switch can be substituted with an optional out-

board LED (P/N 8634 for Blue LED and 8633 for red LED) and an outboard

valet switch (P/N 8631).

Bitwriter® interface - 3-pin black plug

The black 3-pin port is provided for programming the unit using the Bitwriter

(p/n 998T). When using the Bitwriter, it is possible to conﬁgure any and all of

the programmable functions as well as lock the Remote Control and System Fea-

tures Learn Routines so that unauthorized users cannot change the conﬁguration

or program remote controls to the unit.

When the learn routines have previously been programmed using the

Bitwriter, they may have been locked. Before proceeding with repro-

gramming the learn routines, they must be unlocked with the Bitwriter

- this cannot be done manually with the Valet switch.

Note

Bitwriters require software v2.6. Bitwriters with date code of 6A or older

require an IC upgrade (p/n 998M). Bitwriter 2 compatible. Some bitwriters

with a date code of 6B do not require the IC upgrade refer to Tech Tip #1112

for more infor mation. Bitwriter 2 compatible.

Table of Contents