Valet Modes; Panic Mode - Directed Electronics PS-4461TWE-FM User Manual

Valet Modes

When the vehicle is in Valet Mode, the remote starter functionalities and alarm (if configured) are
disabled. If the vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent
the engine from being remote-started accidentally.
Any of the following features will put your remote car starter into Valet Mode:
Ignition Valet: This feature allows you to put your system into Valet Mode by
using the ignition key.
Remote valet: This feature allows you to put your system into Valet Mode by
using the transmitter.
To put the system into Valet Mode
To put the system into Valet mode using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions. The parking lights will flash
three times.
2. Turn the ignition OFF.
3. The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode.
4. The icon will appear on your LCD remote if
To put the system into Valet mode using the TRANSMITTER (Remote Valet Mode):
1. Press the and buttons simultaneously until the
remote.
2. The LED on the antenna will come ON solid to indicate that the vehicle has successfully
entered Valet mode
To put the system out of Valet Mode
To put the system out of Valet mode using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 sec., turn the key 5 times
successively into the IGNITION/RUN and OFF positions.
2. The parking lights will flash twice.
3. Turn the ignition OFF.
4. The LED on the antenna will flash quickly to indicate that the vehicle is now out of Valet
mode.
5. The icon will disappear on your LCD remote if
To put the system out of Valet mode using the TRANSMITTER (Remote Valet Mode):
x
Press the and buttons simultaneously until the
LCD remote.
The system will warn you if someone attempts to remote start the vehicle while in Valet Mode:
The parking lights will turn ON then OFF; then Flash twice.

Panic Mode

Note: Panic mode can only be activated if the horn has been adequately configured by the
installer.
In an emergency situation, you can activate panic mode by pressing and holding the
button for more than 3 seconds, until the horn starts honking. If the vehicle is under a remote start,
the engine will shutdown automatically before setting off the horn. You can stop the horn by
pressing:
P.12
or button is pressed.
icon will appear on your LCD
or button is pressed.
icon will disappear from your
OR
User Guide