Directed Electronics Viper 5501 Installation Manual page 63

Hide thumbs Also See for Viper 5501:
Table of Contents

Advertisement

The vehicle will start, but will only run for 10 seconds.
1.
Is the remote start programmed for voltage sense? If this does not work, a
tach wire should be used.
2.
Check shutdown diagnostics.
The climate control system does not work while the unit is operating the
vehicle.
Either the wrong accessory wire is being energized or more than one ignition
or accessory wire must be energized in order to operate the climate control
system.
Manual Transmission Start diagnostics
When enabling MTS, if you get a failure notification from the remote or the
vehicle fails to remain started when you shut off the key, check for following:
Hood Open (gray wire)
Foot Brake active (brown wire)
No Parking Brake input-Black/white neutral safety wire not showing
ground with parking brake set.
Tach not hooked up or programmed
Toggle switch not installed or not in the ON position.
© 2008 Directed Electronics. All rights reserved.
63

Advertisement

Table of Contents
loading

Table of Contents