Remote Start Input - 5-Pin Connector - Directed Electronics Viper 5501 Installation Manual

Hide thumbs Also See for Viper 5501:

Table of Contents

Remote start input - 5-pin connector

BLACK/WHITE

Connect this wire to a ground source if installing this unit in an automatic trans-

mission vehicle. If this unit is being installed in a manual transmission vehicle then

connect it to the emergency brake wire. This input MUST rest at ground in order

for the remote start system to operate.

Important! Always perform the steps outlined in Safety Check section to verify

that the vehicle cannot be started in ANY drive gear and that the override switch

is functioning properly.

VIOLET/WHITE

This input provides the module with information about the engine's revolutions

per minute (RPMs). It can be connected to the uncommon colored wire of the

fuel injector, the crankshaft position sensor, the camshaft position sensor or the

negative side of the coil in vehicles with conventional coils. In multi-coil and high

energy ignition systems locating a proper signal may be more difﬁcult. (See

Finding the Wires You Need section of this guide.) Once connected, you must

teach the system the tach signal.

Note: This wire MUST be used when installing this unit on a manual transmis-

sion vehicle.

BROWN

This wire MUST be connected to the vehicle's brake light wire. This is

the wire that shows (+) 12V when the brake pedal is depressed. The re-

mote start is disabled or shut down when the brake pedal is depressed.

Important:

on a manual transmission vehicle.

(-) NEUTRAL SAFETY SWITCH INPUT

TACHOMETER INPUT WIRE

(+) BRAKE SHUTDOWN WIRE

This wire MUST be used when installing this unit

Table of Contents