Directed Electronics Viper 5501 Installation Manual page 19

Hide thumbs Also See for Viper 5501:

Table of Contents

BLACK/WHITE

H1/9

Connect this wire to the optional dome light supervision relay as shown below:

Important! This output is only intended to drive a relay. It cannot be connected

directly to the dome light circuit, as the output cannot support the current draw

of one or more light bulbs.

WHITE/BLUE

H1/10

This input comes from the factory set to 1 activation pulse. This means that it is

necessary to have a single ground pulse on the white/blue wire for the remote

start to activate or to deactivate.

The H1/10 wire can also be used to activate the Turbo Timer mode when the

car is running and this wire receives a ground.

Note

The number of activation inputs can be programmed to 1 or 2 pulses with

an optional momentary switch. This setting affects both the input wire and the

remote control when operating the remote starter.

(-) 200mA DOME LIGHT OUTPUT

(-) REMOTE START/ TURBO TIMER ACTIVATION INPUT

To white/blue activation

input on system

Table of Contents