Directed Electronics Viper 5501 Installation Manual page 55

Hide thumbs Also See for Viper 5501:

Table of Contents

3-9 Diesel Timer—Wait-To-Start Input

- Timed 15, 30, 45 SECONDS:

Default is the "Wait-to-Start" input control wire, or programmable to ignore the

input control wire by a delay of 15 (2), 30 (3), or 45(3) seconds. This feature

can also be optionally programmed with the Bitwriter®, with a delay from 1 to

90 seconds.

3-10 Accessory State During Wait-To-Start On:

This feature will allow the se-

lection of the accessory output to be ON or OFF during wait-to-start. Use the

two-honk setting for OFF.

3-11 2nd Status Output: Normal:

This feature will allow selection of status

output or a rear defogger mode that turns on ten seconds after the vehicle has

started if the vehicle interior temperature is below 55 degrees F. The defogger

mode has two selections, latched, the LED will ﬂash twice, or pulsed, the LED will

ﬂash three times. Latched mode will only stay on for 10 minutes.

Note: When the defogger mode is on, the output will always be active and can

be turned on independently with the remote for a one-time activation. (See the

Remote Functions table.)

3-12 Parking Lights Constant:

In the default setting, the parking lights (if connect-

ed) will come on solid during the remote start runtime. In the two - ﬂash setting

the parking lights will ﬂash during the remote start runtime. In the OFF setting, the

parking lights will not come ON or ﬂash, when the vehicle is remote started.

3-13 Anti-Grind On:

With the anti-grind On (default) the ground-when-armed

output is active during remote start operation. This activates the optional starter

kill relay and prevents the customer from re-cranking the car with the key, when

doing key takeover. If accessories such as a voice module or window module

are added to the unit, it may be necessary to use the two-honk setting to pro-

gram this feature OFF.

3-14 Tach Mode Starter Release:

Normal: Use the two-honk setting to in-

crease time by 15% of the original tach programmed time. The LED will ﬂash

twice (2). To decrease by 15% of the original programmed time, the LED will

ﬂash three (3) times.

Table of Contents