Directed Electronics Viper 5501 Installation Manual page 54

3-3 Crank Time 0.6
4.0 (9) SECONDS: If the unit is programmed for no engine checking or voltage
sense, the crank time must be set to the appropriate duration. The default setting
is 0.6 second and the LED will flash once. If a different crank time is desired,
toggle through the higher settings by using the two-honk settings.
3-4 Run Time 12 (1)
that the system will operate the engine until the system "times out". The system
may be shut down using the remote or any of the shutdowns at any time. Using
the Bitwriter®, the run time can be programmed for any duration from 1-60
minutes.
3-5 Activation Pulse One:
the remote start sequence. The default setting is 1-pulse.
Note: This setting affects both the input wire and the remote control.
3-6 Turbo Mode:
5 min (4) On 10 min (5): In the Off setting the turbo mode does not function. In
the On and timed setting, the remote start can be used as a turbo timer. The car
remains running for the programmed runtime, and the ignition is turned Off.
Important:
remote start needs to be connected and programmed.
3-7 Timer Mode Run Time—12min (1)
the time in minutes that the system will operate the engine until the system "times
out" when the remote start activates in timer mode. Use the two-honk setting for
3 min(2), 6 min (3), 9 min (4) : This is the maximum operation period and the
system may be shut down using a shutdown at any time. Using the Bitwriter®,
the run time can be programmed for any duration from 1-16 minutes.
3-8 Flex Relay Function:
function the same as the pink ignition 1 wire, in accessory setting the flex relay
will function the same as the Orange accessory 1 wire, in starter setting the flex
relay will function the same as the purple starter 1 wire.
54
(1) 0.8 (2) 1.0 (3) 1.2 (4) 1.4 (5) 1.6 (6) 1.8 (7) 2.0 (8)
, 24 (2) 60 (3) MINUTES:
This allows the system to use 1 or 2 pulses to activate
The factory default is OFF (1). On1 min (2), On 3 min (3) On
For this feature to work the tachometer wire on the
Ignition 2 (1) In the factory setting, the flex relay will
Selects the time in minutes
, This is the default setting.
© 2008 Directed Electronics. All rights reserved.
Selects