Table of Contents
Advertisement
Step
1
Auto Learn Standard Configuration* (default). The auto learn con-
figuration will automatically setup the remote button configuration.
Note
figuration.
2
Delete remotes: This feature will erase all remotes from the memory
of the security system. This is useful in cases when a customer's
remote is lost or stolen.
Note: This will not reset the programmed features of the system or
reset the Virtual Tach setting.
3
Reset Features: This resets all the features of the system to the fac-
tory default settings.
Note: This feature does not delete the remotes from the system or
reset the Virtual Tach setting.
4
Virtual Tach Reset: Deletes all previously learned values for Virtual
Tach, and on the next remote start sequence the unit will begin
virtual tach initialization.
Note: The "Zap" feature on the Bitwriter will not reset the Virtual
tach setting.
Learn Routine is exited if:
The ignition is turned off
The program switch is pressed too many times
More than 30 seconds elapses between steps
© 2008 Directed Electronics. All rights reserved.
Due to the Supercode protocol, you cannot change the con-
:
3.Transmit. Press the
The vehicle's horn honks to confirm that the code has
been successfully programmed. It is not possible to teach
a remote control button to the system more than once.
4. Release. Once the code is learned, you can
advance from one function step to another by re-
leasing
the
it to advance function steps and then holding it.
Function
button on the remote control.
Valet/Program
switch
and
tapping
39
Advertisement
Table of Contents
