Directed Electronics 474A Owner's Manual
  1. Manuals
  2. Brands
  3. Directed Electronics Manuals
  4. Remote Starter
  5. 474A
  6. Owner's manual

Directed Electronics 474A Owner's Manual

Remote start system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Congratulations
Congratulations on the purchase of your state-of-the-art keyless entry
and remote start system. Reading this Owner's Guide prior to using
your system will help maximize the use of your system and its many
features. For more information please visit us online at:
www.automatecarsecurity.com.
For any additional questions please contact your authorized Directed
dealer or Directed at 1-800-753-0600. Additional support is also
available at:
http://support.directed.com.
What's included
•
Two 4- button remote controls (P/N 474A)
•
Your warranty registration card
•
Quick reference card
•
This owner's guide
© 2010 Directed Electronics. All rights reserved.
Gf
EZSDEI474V
FCC ID:
66
RPN 474A 2
CODES
BATTERY: CR2032
Warranty
Card
0890
!
Quick
Reference Card
G4103A 2010 07
FCC ID:
EZSDEI474V
66
RPN 474A 2
CODES
BATTERY: CR2032
0890
!
i

Advertisement

Table of Contents
loading

Related Manuals for Directed Electronics 474A

Summary of Contents for Directed Electronics 474A

  • Page 1 For any additional questions please contact your authorized Directed dealer or Directed at 1-800-753-0600. Additional support is also available at: http://support.directed.com. What's included • Two 4- button remote controls (P/N 474A) • Your warranty registration card • Quick reference card •...

  • Page 2: Important Information

    Replacement remote controls If additional remote controls are desired, please see your authorized dealer or visit us at www.directedstore.com to order. Your 1-way re- placement part number is 474A. © 2010 Directed Electronics. All rights reserved.

  • Page 3: Table Of Contents

    Disabling the Remote Start system .............11 Owner Recognition ..................12 Rapid Resume Logic ..................12 Programming Options ..................13 Glossary of Terms....................14 Convenience Expansions .................15 Government Regulations ..................16 Warning! Safety first ..................17 Caution ....................18 Patent information ...................19 © 2010 Directed Electronics. All rights reserved.

  • Page 4: Getting Started

    Locate the small slot on the side of the remote control. Insert a small slotted screwdriver or equivalent tool into slot and pry the case apart. Replace battery while verifying the correct polarity and then snap case together. © 2010 Directed Electronics. All rights reserved.

  • Page 5: Remote Control Functions

    Your 1-way remote coin cell battery can be changed by using a small at blade screwdriver to pry case apart. Replace battery and then snap case together. Buttons Car Finder is controlled by pressing these two buttons. © 2010 Directed Electronics. All rights reserved.
  • Page 6 Your 1-way remote coin cell battery can be changed by using a small at blade screwdriver to pry case apart. Replace battery and then snap case together. Your 1-way remote coin cell battery can be changed by using a small at blade screwdriver to pry case apart. Replace battery and then snap case together. © 2010 Directed Electronics. All rights reserved.

  • Page 7: Using The System

    The vehicle should start. If it does not start, you may have waited too long; turn the ignition off and repeat the process. Location of Valet button: ____________________ © 2010 Directed Electronics. All rights reserved.

  • Page 8: Panic Mode

    In gasoline vehicles the engine will start 4 seconds after the parking lights flash, in diesel vehicles the engine starts after the WAIT-TO-START timer has expired. Bank and Channel © 2010 Directed Electronics. All rights reserved. Tune mode present and text indicator...
  • Page 9 Scan mode Your 1-way remote coin cell battery can be changed by using a small at blade screwdriver to pry case apart. Rep • Remote control button is pressed once. SOUND SCAN AUDIO © 2010 Directed Electronics. All rights reserved.

  • Page 10: Rear Defogger (Optional)

    When turning the defogger On, if remote start is On the lights turn Off then flash 3-times before returning to normal. The defogger output will activate as programmed. © 2010 Directed Electronics. All rights reserved.

  • Page 11: Valet Take-Over

    Your 1-way remote coin cell battery can be changed by using a small at blade screwdriver to pry case apart. Rep Press and release the buttons at the same time. The lights flash 5 times slowly allowing you to locate your ve- hicle. © 2010 Directed Electronics. All rights reserved.

  • Page 12: Timer Mode

    The parking lights flash 4 times indicating timer mode is exited. Important! Timer Mode should be used only in open areas. Never start and run the vehicle in an enclosed space such as a garage or carport. © 2010 Directed Electronics. All rights reserved.

  • Page 13: Starter Anti-Grind Circuitry

    To disable the remote start, move the shutdown toggle switch to the OFF position. The switch can be installed in a location of your choice. Check with your installer for recommended locations. Location Of Shutdown Switch _________________________ © 2010 Directed Electronics. All rights reserved.

  • Page 14: Owner Recognition

    Rapid Resume Logic This Directed Electronics system will store its current state to non-volatile memory. If power is lost and then reconnected the system will recall the stored state from memory. This means if the unit is in Locked Mode and the battery is dis con nect ed for any reason, such as servicing the car, when the battery is re con nect ed the unit will still be in Locked Mode.

  • Page 15: Programming Options

    • The horn honk confirmations for locking and unlocking can be or Off. In order for this feature to work, it must be programmed connected to the system. © 2010 Directed Electronics. All rights reserved.

  • Page 16: Glossary Of Terms

    Valet Button: A small push button mounted at a discretionary location inside the vehicle. It is used to override the Failsafe Starter Kill when a ® remote control is lost or damaged. © 2010 Directed Electronics. All rights reserved.

  • Page 17: Convenience Expansions

    Power Trunk Release: The system’s auxiliary output can be programmed to operate a factory power release for the vehicle's trunk or hatch. If the factory release is not power-activated, Directed Electronics 522T trunk-release solenoid can often be added. Power Window Control: Power window control is provided with Di- rected Electronics 529T or 530T systems.

  • Page 18: Government Regulations

    Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device. © 2010 Directed Electronics. All rights reserved.

  • Page 19: Warning! Safety First

    Safety Check outlined in the product installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit has not been © 2010 Directed Electronics. All rights reserved.

  • Page 20: Caution

    PAY FOR INSTALLATION OR REINSTALLATION COSTS. Caution This product is designed for fuel injected, automatic transmission ve- hicles only. Use of this product in a standard transmission vehicle is dangerous and contrary to the product's intended use. © 2010 Directed Electronics. All rights reserved.

  • Page 21: Patent Information

    333,795 383,690 4,887,064 5,285,186 5,783,989 340,000 390,830 4,897,630 5,315,285 5,798,711 344,905 392,944 4,922,224 5,357,560 5,872,519 345,317 4,327,444 4,987,402 5,532,670 5,900,806 International Patents: Australia: 694,925 Canada: 1,315,859 and 2,067,099 Taiwan: 91817 Other patents pending © 2010 Directed Electronics. All rights reserved.

Table of Contents