Menu, Key Option, Key Groups; Clearing A Key Group - Telex KP-812 User Manual

Menu, Key Option, Key Groups

You can set up a key group, so that when you activate one key (the master key) all keys in the group
will activate. Up to four key groups can be set. The Master LED is indicated by red, while the Slave
LED is indicated by green.
1.
2.
Note: Tap the encoder knob once to bypass the master. You can define the slaves without the
master. For example, using a GPI Input to trigger a group.
3.
4.
5.
6.
7.
Note:

Clearing a Key Group

1.
2.
3.
4.
5.
6.
7.
44
Select Key Groups, then tap the encoder knob to select.
Group 1 displays.
Tap the encoder knob.
Tap Master displays. The master key is the key that you will press to activate the
group.
Tap the intercom key that you want to use as the master.
Once you have assigned the master, turn the encoder knob to display Slaves and tap
the encoder knob.
Tap Slaves displays. Slave keys are the keys that will activate along with the master
key.
Tap one or more intercom keys to select them as slave keys. Tap the key again to
remove it from the key group.
Once you are finished, hold the encoder knob for 1 second to exit.
Activating the master key should now cause it and all slave keys to activate. The
LEDs for each key will activate according to the current key assignment for that call.
Run Service Menu, Save Cfg to store Key Group Settings.
Key group settings will continue on keys even if you change the key assignments.
Select Key Groups, then tap the encoder knob.
Group 1 displays.
Tap the encoder knob.
Tap Master displays.
Tap the encoder knob to clear the master key assignment. The LED turns off.
After tap the encoder knob, Tap Slaves displays.
Tap all the keys where the LEDs are lit green. This will turn the LEDs off.
Hold the encoder knob for 1 second to exit.
The key group is now cleared.
Run Service Menu, Save Cfg to store the cleared key group setting.
KP-812 Keypanels User Manual