Addressing - Telex KP-812 User Manual

Addressing

Note: SET ADDR must be used during installation or whenever the keypanel is reset or moved to a new port.
Determining the Keypanel Address, ADAM and ADAM CS Intercoms
See Table 1 on page 9.
Determining the Keypanel Address, Zeus Intercom Systems
The address is the number (1-8) printed next to the connector on the back panel of the Zeus Frame.
(This number repeats for each group of 8 connectors. The intercom system is able to distinguish
between to keypanels set to the same address by the group where each one is connected.)
Setting the Keypanel Address
1.
2.
3.
4.
5.
6.
KP-812 Keypanels User Manual
Turn the the encoder knob and scroll to Menu, tap the knob once.
Turn the encoder knob and scroll to Service, tap the knob once.
Turn the encoder knob and scroll to Set Address, tap the knob once.
Turn the encoder knob and scroll to Address X, tap the knob once.
Tap on the selected address.
The CWW will display Save Config?
Tap the encoder knob to save.
The displays will show "*******" and change to " xxxxxx", where xxx is the address.
31