Replace The Flash Cards To Upgrade The Firmware Version To 2.0 Or Later; Cable The Csi-200, Kp-812 And Frame - Telex KP-812 User Manual

To convert an existing KP-812 keypanel to use the coaxial connection, do the following:
Requirements:
You will need to upgrade the KP-812(9030-7761-000 [rackmount unit] 9030-7761-001 [desktop unit]) board to
Rev J.
Flash Cards to Upgrade the Firmware Version to 2.0 or later
Flash Chip
U21
U22
1. On the KP-812 board, find U21 and U22 flash cards.
2. Using IC pullers, remove both flash cards.
3. Replace the existing flash cards with the new flash cards (see above for part numbers). Carefully
snap the flash cards in place.

Cable the CSI-200, KP-812 and Frame

1. Connect a DB-9 connection to Frame A or Frame B (depending upon the channel being used) on
the CSI-200.
2. Connect the opposite end of the DB-9 cable to the Frame you want to use (ADAM, ADAM CS,
Zeus, or Cronus).
3. Connect the coaxial calbe (up to 1000 ft) to Coax A or Coax B on the CSI-200 (depending upon
the channel being used).
4. Connect the opposite end of the coaxial cable to the KP-812 COAX connect on the back of the
unit.
5. Using AZedit, add 5 ms to the Panel Poll Delay (Keypanels>Edit button> Advanced).
6. Click Apply.
7. Send changes to the frame.
NOTE: Panel Poll Delay must be set for each CSI-200 connected to the frame.
8. Power ON the CSI-200.
9. Power ON the KP-812.
NOTE: On the CSI-200, the Frame LED is solid green for the channel that is connected and active. The
Transfer (TX) and Receive (RX) LEDs for the specified channel flash rapidly to signify the connec-
tion is active. On the KP-812, dashes or panel assignments on the port are displayed in the panel
window.
KP-812 Keypanels User Manual
Old Part Number New Part Number
9015-7761-021
9015-7761-022
23