After Working Inside Your System; Recommended Tools; Removing And Installing A Blade; Removing The Blade - Dell HHB Owner's Manual

Related tasks
Removing the system cover
Related reference
Safety instructions

After working inside your system

Prerequisites
Follow the safety guidelines listed in safety instructions section.
Steps
1. Install the system cover.
2. Install the blade in the enclosure.
3. Turn on the blade.
Related tasks
Installing the system cover
Related reference
Safety instructions

Recommended tools

You may need the following items to perform the procedures in this section:
• Phillips #1 and #2 screwdrivers
• T8 and T10 Torx drivers
• Wrist grounding strap
• Hex nut driver-5 mm

Removing and installing a blade

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
NOTE: These procedures are applicable only for full-height and half-height blades. For information about removing and
installing quarter-height blades from a sleeve, see the blade's Owner's Manual at Dell.com/poweredgemanuals.

Removing the blade

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Turn off the blade by using OS commands or the CMC, and ensure that the blade's power is off.
52 Installing and removing blade components