Related tasks
Removing the blade
Related reference
Safety instructions
System cover
The system cover protects the innyards of the server, while also help maintaining proper flow of air inside the server. The removal of the
system cover also actuate the intrusion switch and this aids in maintaining system security.
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in safety instructions section.
2. Turn off the blade by using CMC.
3. Remove the blade from the enclosure.
4. Install the I/O connector cover.
Steps
1. Press the release button and slide the cover toward the back of the blade.
2. Lift the cover away from the blade.
Figure 9. Removing the system cover
1. alignment guides on the system cover and the chassis
3. release button
Related tasks
Installing the system cover
Related reference
Safety instructions
2. system cover
4. I/O connector cover
Installing and removing blade components
55