Dell HHB Owner's Manual page 81

support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that came with the product.
1. Follow the safety guidelines listed in safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in the Before working inside your system section.
4. Remove the mezzanine card.
Steps
1. Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.
2. Lift the card from the system board.
Figure 31. Removing the NDC
1. slot on the NDC
3. NDC
5. connector
Next steps
1. Install the NDC.
2. Install the mezzanine card.
3. Follow the procedure listed in the After working inside your system section.
Related tasks
Before working inside your system
Removing the mezzanine card
Installing the Network Daughter Card
Installing the mezzanine card
After working inside your system
Related reference
Safety instructions
2. screw (2)
4. standoff (2)
6. tab projections
Installing and removing blade components 81