Telex Azedit Software Manual page 42

Panel Poll Delay Activation
Panel Poll Delay is typically used when a keypanel's data line is connected to the intercom port via a modem link
from a remote location. By setting a delay time, the intercom system waits longer for data transmissions from the
remote keypanel. The delay time can be set anywhere from 0 milliseconds (1/1000 of a second) to 500 milliseconds
(500/1000's of a second, or 1/2 second).
Important: Connect only one remote keypanel per Audio I/O card, and assign only one panel poll delay per Audio I/O
card. Also, since excessive poll delay can impair system performance, use the minimum delay required to assure
proper operation of the remote keypanel. However, allow for the possibility of fluctuations in the delay time.
To activate the panel poll delay, do the following:
1. From the Options menu, select Preferences.
The Application Preferences screen appears.
2. Select the Advanced tab.
The Advanced screen appears.
3. Select the Enable panel poll delay support check box.
4. Click Apply.
5. Click OK.
Panel Poll Delay is activated and may be adjusted in the Keypanel / Ports Configuration Advanced screen.
42
Telex Communications