Keypanel/Ports Configuration - Telex Azedit Software Manual

Keypanel/Ports Configuration

The Keypanel/Ports configuration screen is used to configure a keypanel in the intercom system. From this screen,
you can setup your keypanels, choose different screen View options, restrict users from setup, set specific priorities,
set delay times, IFB listen destinations, enable tone, keypanel privacy, TIF dial out restrictions, and assign a port as a
TIF.
The Setup page of the Keypanel/Port Configuration screen is for higher-level configuration options, while the
Advanced Tab allows you to assign more specific options and restrictions to a keypanel.
To open the Keypanel/Port Configuration screen, do the following:
From the Keypanel setup screen, click Edit....
1
The Keypanel/Port Configuration screen appears.
Setup
Use the Setup tab to configure an intercom port for use with a keypanel. Each keypanel can have up to four setup
pages of key assignments, and each setup page can assign up to 16 pairs of talk and listen keys. Typically, one
setup page is used for the main keypanel, and one setup page is used for each expansion panel connected to the
main keypanel.
Note: Some keypanels may have more or less than 16 keys. There may be cases where all 16
keys on a setup page are not used. There may also be cases, such as with the KP-32 keypanel,
where the keypanel itself uses all of the keys on more than one setup page.
Telex Communications
33