Status Bar; Standby Controller Status; Stby Mc Status - Status Column - Telex Azedit Software Manual

Standby Controller Status

Use Standby Controller Status to view connection status and data communication errors between the standby
master controller card and the active master controller card.
Standby Controller Status Screen Information

Stby MC Status - Status Column

"-- --"
The Stby MC Status - Status columns show the status between the master controller and the standby master
controller Two consecutive dashes indicate that there has never been any data communication between the standby
controller and the master controller during the current edit session. This could be because the device is not
connected.
Bad Cut:
Indicates that there was a connection to the standby controller, but it is now not connected or there may be a power
failure or other problem somewhere in the system.
OK Cur:
Indicates that the standby controller is connected and operating, and that it has been updated with the current
intercom system configuration.
OK Old:
Indicates that the standby controller is connected and operating, but that it has not been updated with the current
intercom system configuration.

Status Bar

Status Bar activates the status bar at the bottom of the AZedit window.
Toolbar is available under the View menu.
Telex Communications
173