Remote Intercoms; Reset Capabilities; Resource Type Pane; Restrict Listen Key - Telex Azedit Software Manual

Remote Intercoms

Use Remote Intercoms to view the status of remote intercoms. From this screen, you can choose to clear key
assignments that refer to disconnected intercoms.

Reset Capabilities

Use Reset Capabilities to reactivate any capabilities of AZedit that may have been disabled. AZedit capabilities may
have been disabled in several ways:
Some AZedit features may be disabled by default because they are not commonly used.
AZedit capabilities may have been disabled by directly editing the [capabilities] section of the AZedit.ini file
(This file is located in your Windows folder and can be edited in any text editor, such as Windows Notepad.)
Editing the [capabilities] section of the AZedit.ini file is not recommended.
AZedit features may have been disabled by connecting to an intercom system that uses older firmware, with
fewer capabilities than what is supported by your AZedit version. In this case you will see a prompt that
there is a capabilities conflict, and you will be given the choice to reset AZedit capabilities to match the
intercom system. If you do this, some capabilities may be deactivated, and you will not be able to use those
features. See Capabilities Conflict Message for further details.
Reset Capabilities can only be selected in FILE mode.

Resource Type Pane

When you are viewing most screens, the Resource Type Pane displays the type of resource that is currently
selected. In the keypanel setup view or the LCP-102 setup view, if you move the cursor over an assignment, this
pane displays the type of resource that is assigned.
Note: Whenever there is a resource type displayed here, the pane immediately to the right of this pane
will indicate the identification number of the resource.
Restore
Restore returns the AZedit window to the previously changed size.

Restrict listen key

To prevent a keypanel operator from changing a key assignment, select the Restrict check box (R) above that key
assignment. (Or press Ctrl+R on the computer keyboard while the key assignment is selected.)
Note: You may wish to set all of the restriction check boxes for all setup pages at all intercom
ports. You can do by using the Copy and Paste Special commands.
168
Telex Communications