Setting The Fork Offset; Removing The Fork Legs; Installing The Fork Legs - KTM 450 SMR Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE
x

Setting the fork offset

x

Removing the fork legs

x

Installing the fork legs

Remove the lower triple clamp. (
Remove screw
Clean the parts and check for damage.
Rotate the steering stem 180° and insert into the triple clamp. Mount and tighten
screw .
Specification
Screw, bottom steering
head
Install the lower triple clamp. (
500104-10
Remove front wheel. (
Remove screws
Hang the brake caliper
500200-12
Loosen screw
Loosen screw
500094-12
Check parts for damage and wear. Replace damaged or worn parts.
Position the fork legs.
Info
The topmost sunk nut in the fork leg must be flush to the upper edge of the
upper triple clamp.
Position the bleeder screw
400248-10
Fully tighten screw
Specification
Screw, top triple clamp
Fully tighten screw
Specification
Screw, bottom triple clamp
500094-11
P. 30)
. Remove the steering stem.
M20x1,5
P. 30)
P. 46)
and take off clamp.
and the brake line loosely to the side.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
to the front.
.
M8
.
M8
®
60 Nm Loctite 243™
(44.26 lbf ft)
17 Nm
(12.54 lbf ft)
12 Nm
(8.85 lbf ft)
29