Service & Adjustments - H&S LW1100 Operator's Manual

MAINTENANCE PRECAUTIONS
WHEN PERFORMING ANY INSPECTION OR MAINTENANCE WORK ON THE ELECTRONIC
SYSTEM, ALWAYS TAKE SPECIAL CARE TO PREVENT INJURY TO YOURSELF AND OTHERS
OR DAMAGE TO THE EQUIPMENT.
The following are general precautions which should be closely followed.
1. Do not have hydraulic power available to the valves when performing electrical tests.
2. Never operate or test any function with any other person near or on the machine.
3. Take care to prevent metal tools from coming in contact with sensitive electronic components.
4. Turn power off before connecting or disconnecting valve coils or other electrical loads.
ROUTINE MAINTENANCE
1. Clean transmitter regularly with a damp cloth and mild detergent.
2. Periodically check switch mounting nuts and compression fittings for tightness.
3. Inspect electrical wiring for wear points or other damage. Repair as required.
4. Inspect all connections (especially to the valves) for looseness or corrosion. Tighten and/or "seal" as
necessary.
REMOTE CONTROL
Description
KAR-TECH's control system is a micro-controller based system designed to provide the machine operator
with the possibility to remotely operate equipment. The machine operator is still required to follow OSHA
and other applicable standards when operating the equipment. The control system consists of two major
modules; the controller unit, and the receiver with a hand held transmitter. The receiver is operated by
connecting the unit to the controller and turning on the power switch. The hand held transmitter has two
buttons that can control the system, and a red LED to indicate when the unit is transmitting. The buttons
operate the Start and Stop functions of the controller.
Display
The system is designed with an integrated 4-Character
Alphanumeric red LED Intelligent Display (located just
center inside control box). This display serves two
functions:
1. The display will show the number of bales the
Linewrap has wrapped. The counter can not be reset.
2. The display will show diagnostic information for
troubleshooting.
SERVICE & ADJUSTMENTS
-23-