H&S LW1100 Operator's Manual page 26

TRANSMITTER
Lights:
There is a Green and a Red light both inside the receiver and on
the transmitter. The Green LED on the transmitter and receiver
blinks every 1/2 second if there is communication between the
transmitter and the receiver. It will blink once a second if there is
no communication (i.e.: no power to the receiver). The Red LED
blinks a number of times for each output if there is a short or an
open to that output. For example 4 blinks and a pause means
output number 3 has a problem. The transmitter's Red LED also
blinks once every second if the batteries are low and need to be
replaced.
Address programming:
There are over 64000 different addresses (identities) for each
transmitter and receiver. In many cases both transmitters and
receivers are matched at the factory. If matching is required:
1. Remove the receiver cover.
2. Apply power to the receiver.
3. Place the jumper that is stored in the receiver across the
address code jumper inside. Both the green and red lights will
toggle inside the receiver.
4. Press the Power button for 10 seconds. At this point, both
lights will toggle on the transmitter.
5. Release the Power button and wait for 1 second or until the
green and red lights stop toggling in the receiver.
6. Remover the Jumper.
7. Replace the cover.
SERVICE & ADJUSTMENTS
PLUG PIN# DESCRIPTION
#1-Ground
#2-No Connection
#3-No Connection
#4-No Connection
#5-Stop Output (Button #1)
#6-No Connection
#7-No Connection
#8-No Connection
#9-Steer Right Output (Button #3)
#10-Start Output (Button #2)
#11-Steer Left Output (Button #4)
#12-Power (9 to 35 VDC)
-24-