Operation & Adjustments - H&S 7116 Operator's Manual

EMERGENCY SHUTDOWN
Stop the tractor engine, remove ignition key, and allow all mechanisms to stop before
cleaning or working on the machine.
Latch System
The Latch System (A) is mounted at the front of the pole. When the rake is in the transport position,
make sure that the safety pin on each latch is placed in the hole (B) before transporting on the highway.
Before opening for field operation, remove the safety pins and place them in the storage position hole.
Lift up on the handle of the latch to release the transport lock. Hydraulically open the rake to raking width.
Place the safety pins back in the latch mechanism after opening. For transport, remove the safety pins
from the latch mechanism, hydraulically close the rake to transport position, clamp each latch mechanism
around each pin and replace the safety pins.
(A)
(B)
RAKING WIDTH
Raking width is determined by setting the spring loaded stop, located above the rear pole section as shown.
OPERATION & ADJUSTMENTS
-17-
(A)
(B)