Operation - H&S LW1100 Operator's Manual

PLACING WRAPPER IN POSITION
If possible, place the LINEWRAP in a north/south facing direction. This will allow minimal freezing to the
bales in the winter as the sun works from east to west. After placing in position, shorten the tongue into
the steering position by lifting the spring loaded telescoping lock pin and sliding the telescoping tongue in.
Once the tongue has been retracted, the tongue can be pinned to the hand crank or hydraulic steer
mechanism. Steering will enable the machine to be guided around contours or along fence lines.
INSTALLING PLASTIC FILM
To install plastic film on the machine, shut off engine, and
open side shield on the engine side of machine. Rotate
the hoop upward by hand until the first pre-stretcher is
accessible. Note that there are two different ways to put
the roll on the machine as shown by the decal. The tack
side of the film should always be to the bale side of the film.
The tack side of the film can be on either side and can be
determined by folding the film together inside to inside or
outside to outside. Which ever side pulls apart harder is
the tack side of the film. With the film correctly mounted,
route the film through the pre-stretcher as shown in the
decal. Go the other side of the machine, open the shield
and repeat the process described above to install the
second roll of plastic film.
BALE GUIDES
Adjust the bale guides so they are a couple of inches wider than the diameter of the size of bales to be
wrapped. These guides are used to keep the bales centered while wrapping. DO NOT load bales onto
the guides. Improper use of the guide may result in damage to the machine. Adjustment can be made by
removing 4 pins, 2 rear and 2 front, rotating the bale guides and replacing the pins.

OPERATION

Always shut engine
off before making
adjustments.
-17-