H&S LW1100 Operator's Manual page 21

OPERATION
CONTROLS
There are four switches on the control panel. The mode
selection switch allows the operator to wrap bales
manually, automatically, or from the optional remote
control. The Linewrap will not operate in the remote
position, unless the remote option is installed on the
machine. The manual hoop switch allows the operator
to rotate the hoop while in the manual mode. The
manual pusher switch allows the pusher to be moved
forward or reverse while in the manual mode. The
start/reset switch is to be used after starting the
engine or after the emergency stop has been activated.
IF THE EMERGENCY STOP IS TRIPPED DURING
WRAPPING CYCLE, THE UNIT MUST BE
SWITCHED TO MANUAL OPERATION ON THE
CONTROL PANEL. PRESS THE START/RESET
SWITCH, THEN PRESS AND HOLD THE MANUAL
PUSHER AND HOOP SWITCHES TO BEGIN
WRAPPING AGAIN, WHILE HOLDING SWITCHES,
SELECT THE DESIRED MODE, AUTOMATIC OR
REMOTE ON THE CONTROL BOX TO CONTINUE
NORMAL OPERATION.
BALE ADJUSTMENT SWITCHES
Adjust the hoop start switch to the number 1 as shown.
Adjust the hoop stop/pusher return switch the same
amount of footage as the length of the bale (Markings
are in 1' increments). Example; with a 4' bale the hoop
stop/pusher return switch should be set at the number
5. Be sure wires from switches are placed in the
storage channel below switches.
Always shut engine
off before making
adjustments.
-19-