H&S LW1100 Operator's Manual page 23

MANUAL MODE
If the manual mode is selected after the steps on the previous page, follow these steps to continue
wrapping.
1. Place another bale on the machine, manually engage and hold the pusher switch until it tightens to the
previous bale, then engage and hold the hoop switch to start wrapping.
2. Hold manual hoop wrapping switch and manual pusher forward switch until there is sufficient room to
place another bale on the machine.
3. Release both switches at this time.
4. Engage and hold the pusher reverse switch until the pusher returns to its home position.
5. Repeat the above process to continue wrapping.
AUTOMATIC MODE
If automatic mode is selected after the steps on the previous page, follow these steps to continue
wrapping.
1. Place the Mode selection mode to Automatic.
2. Place another bale on the machine.
3. The start bar will be depressed and the pusher will start to move and push bale. The hoop start switch
will be activated by the pusher and the hoop will begin to rotate. When the pusher stop switch is
activated by pusher, the pusher will stop and return to its home position allowing room for another bale
to be placed on the machine and the process repeated.
REMOTE MODE
If the LINEWRAP is equipped with optional remote and the remote mode is selected after the steps on
the previous page, follow these steps to continue wrapping.
1. Place the Mode selection mode to Remote.
2. Place another bale on the machine.
3. Press the start button on the remote handset.
4. The pusher will start to move and push bale. The hoop start switch will be activated by the pusher and
the hoop will begin to rotate. When the pusher stop switch is activated by pusher, the pusher will stop
and return to its home position allowing room for another bale to be placed on the machine. Repeat the
process.
NOTE: When there are enough wrapped bales on the ground to provide a stable row to push against,
pick up the unwrapped bales that were pushed through the machine and not wrapped. Place these bales
back on to the machine and continue wrapping.
OPERATION
-21-