H&S LW1100 Operator's Manual page 29

LUBRICATION
GREASE FITTINGS
There are numerous grease fittings on the LINEWRAP. If lubricated properly and often enough, it will
prolong the life of your rake. Grease daily during normal use and before and after storage and after power
washing. Use a good grade of high quality grease. Make sure that grease comes out around the shaft on
sleeve type bearings. Wipe off excessive grease to prevent accumulation of chaff or grit around the
bearing. Replace any missing or plugged grease fittings.
Grease locations and recommended intervals are as follows:
Grease the Front Steering Mechanism as needed, at least annually.
Spindle
Spindle
Pivot
Pivot
Tie Rod Ends Pole Pin Tie Rod Pole Pivot
Center Pivot
2 Zerks - 1 on each Tensioner
4 Zerks - Each Hoop Roller Support
Annually Only
Every 20 Hours of Operation
-27-