Lubrication Guide - H&S LW1100 Operator's Manual

Become familiar with all lubrication points and establish a routine to ensure complete
lubrication of the LINEWRAP.
GENERAL INFORMATION
IMPORTANT: Catch and dispose of fluid per local waste disposal regulations whenever service is
performed on hydraulic components, valves, cylinders, hoses, etc.
WHEEL BEARING LUBRICATION, CLEAN & RE-PACK INSTRUCTIONS
Grease wheel bearings as needed depending on amount of travel.
Annually disassemble and clean parts in a solvent. Pack bearings
with a high grade grease. Reassemble, and tighten nut until a slight
drag is felt when wheel is turned. Back nut off and insert cotter pin
into first hole that you see as you back the nut off, bend cotter pin
over and re-install cap.
OIL RESERVOIR
Check the hydraulic oil level in the reservoir regularly. The
level of the 20W hydraulic oil should be maintained above
the half mark on the sight gauge located on the hydraulic oil
reservoir. The filter in the hydraulic tank should be changed
annually.
PUSHER SLIDES
To insure smoother operation and longer life of your
LINEWRAP, apply liberal amounts of grease to the pusher
slides daily, or when the slides appear dry. Additionally,
lubricate the following with a light machine oil:
* The removable fork mounts
* The push-off arm pivots
* The pivot points on the rear tailgate
LUBRICATION
-26-