H&S LW1100 Operator's Manual page 36

ELECTRONICS
Control Box
If there is no power at the control box:
1. Check 25 Amp fuse located in engine start box.
2. Check wiring connections from engine start box to main control box.
On/Off Outputs
There are 3 On/Off outputs with 5 ampere capacity and short circuit, overload protection. Each on/off is
designed with a built in short circuit or no load status circuits. The output status is reported to the machine
operator via display. Refer to the STATUS DISPLAY ERROR CODE CHART of this manual.
On/Off Inputs
The system is designed with 7 digital (switched to 12 VDC) inputs. There are two inputs received from
the remote control unit, and the other inputs from limit switches on the machine.
Display
The system is designed with an integrated 4-Character Alphanumeric red LED Intelligent Display. This
display is used to report the status of the bale count and outputs to the machine operator. If there are
active error codes, they will be displayed. For additional information on error codes refer to the STATUS
DISPLAY ERROR CODE CHART of this manual. If there is no active error, the bale count will be displayed.
Below is an example of how to read the counter in the control box.
1. Open the control panel door by removing the 2 screws.
2. Turn the engine key to the on position.
3. Locate the LED screen; it will be flashing RST (Reset).
4. Push and release the reset switch on the control panel.
5. The LED screen will now be flashing one of the following.
For a bale count up to 9,999 bales, the LED screen will display and alternate between the following;
For 7,345 bales:
Screen 1: CNT
Screen 2: 7345 – or the number of bales up to 9999
For a bale count higher than 9,999 bales, the LED screen will display and alternate between the
following;
For 12,345 bales:
Screen 1: CNT
Screen 2: 0001
Screen 3: 2345 – or the number of bales up to 19,999
Every 10,000 bales, Screen 2 will change numbers, 0002, 0003, 0004, etc.
TROUBLESHOOTING
-34-