Page 1
1136/1140 1136/1140 Top Dog Top Dog FORAGE BOX FORAGE BOX WARNING WARNING READ AND UNDERSTAND THIS MANUAL BEFORE READ AND UNDERSTAND THIS MANUAL BEFORE OPERATING THIS EQUIPMENT. UNSAFE OPERATION OPERATING THIS EQUIPMENT. UNSAFE OPERATION OR MAINTENANCE OF THIS EQUIPMENT CAN RESULT OR MAINTENANCE OF THIS EQUIPMENT CAN RESULT IN SERIOUS INJURY OR DEATH.
H&S WARRANTY H&S Manufacturing Co., Inc. (“H&S”) warrants this product to be free from defect in material and workmanship. Except as noted below, this warranty term is twelve (12) months on labor, and twenty-four (24) months on parts from the date of delivery of the product to the original purchaser by an authorized H&S dealer.
H&S reserves the right to make changes or add improvements to its products at any time without incurring any obligation to make such changes to products previously manufactured. Specifications, statements and descriptions of Products contained in this publication are subject to change without prior notification.
DEALER PRE-DELIVERY CHECKLIST AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS Top Dog After the has been completely set up, check to be certain it is in correct operating order before delivering to the customer. The following is a list of points to inspect. Check off each item as you have made the proper adjustments and found the item operating satisfactorily.
DEALER DELIVERY CHECKLIST AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS This checklist that follows is an important reminder of valuable information that should be Top Dog passed on to the customer at the time this is delivered. Check off each item as you explain it to the customer. This delivery checklist, when properly filled out and signed, assures the customer that the pre- delivery service was satisfactorily performed.
SAFETY INFORMATION YOUR SAFETY ALERT! IS INVOLVED. THIS SYMBOL IS USED THROUGHOUT THIS BOOK WHENEVER YOUR PERSONAL SAFETY IS INVOLVED. TAKE TIME TO BE CAREFUL. REMEMBER: THE CAREFUL OPERATOR IS THE BEST OPERATOR. MOST ACCIDENTS ARE CAUSED BY HUMAN ERROR. CERTAIN PRECAUTIONS MUST BE OBSERVED TO PREVENT THE POSSIBILITY OF INJURY OR DAMAGE.
SAFETY INFORMATION Keep signs in good condition. Immediately replace any missing or damaged signs. RECOGNIZE SAFETY INFORMATION This is the safety alert symbol. When you see this symbol on your machine or in this manual, be alert to the potential for personal injury.
SAFETY INFORMATION W A R N I N G TO PREVENT SERIOUS INJURY OR DEATH BEFORE YOU ATTEMPT TO OPERATE THIS EQUIPMENT, READ AND STUDY THE FOLLOWING INFORMATION. IN ADDITION, MAKE SURE THAT EVERY INDIVIDUAL WHO OPERATES OR WORKS WITH THIS EQUIPMENT, WHETHER FAMILY MEMBER OR EMPLOYEE, IS FAMILIAR WITH THESE SAFETY PRECAUTIONS.
CAP SCREW TORQUE VALUES The specifications below are the torque values for fasteners as it adheres to the SAE torque value standards. All fasteners should be torqued to the proper values found in the figures below unless otherwise specified by the engineering drawing. •...
SET-UP & ASSEMBLY Top Dog Note: Determine right and left side of the by viewing it from the rear. If instructions or parts lists call for hardened bolts, refer to Cap Screw Torque Values page to identify. 1. Check the Top Dog for proper assembly and adjustment. 2.
PREPARING FOR OPERATION PREPARING THE Top Dog Top Dog Properly lubricate the before operating. Refer to the Lubrication Chapter of this manual for locations. Four main apron adjustment bolts with tension springs are located on the idler shaft at the front of the box.
OPERATION UNLOADING Top Dog Park the on level ground whenever possible during unloading. Dog, engage the hydraulics. With the operator in the truck seat, and all others well clear of the Engage the switch for the gate delay. During unloading, move the truck forward to allow the material to fall away from the rear of box. Top Dog When the is empty, disengage the hydraulics.
Page 19
OPERATION BARN DOORS - OPTIONAL Dog. Barn doors are optional on the Latches for the doors are located at the bottom center of the rear doors. These latches lock in the main apron chain of the rear drive shaft to hold doors closed when loading.
ADJUSTMENTS MAIN APRON ADJUSTMENT The four main apron adjustment bolts are spring loaded to help maintain proper tension on the apron chains. Tighten the full threaded bolts to adjust aprons. Aprons are properly adjusted when two cross slats, or about three feet of chain lift off the chain return slides from the front of the box.
OPTIONAL EQUIPMENT TIRE & WHEEL PACKAGES There are many different tire/wheel packages available. Follow the tire manufacturer’s recommended tire Top Dog pressure on the tires that your is equipped with. ROOF HOOD A Roof Hood is available to be installed on either side of the forage box to help minimize crop loss when blowing into it with the forage harvester.
LUBRICATION GUIDE Become familiar with all lubrication points and establish a systematic routine to ensure complete and quick lubrication of the machine. GENERAL INFORMATION IMPORTANT: Catch and dispose of fluid per local waste disposal regulations whenever service is performed on hydraulic components, valves, cylinders, hoses, etc. Grease Zerks Grease daily during normal use and before and after storage and after power washing.
DECAL LOCATION Top Dog Top Dog Your H&S was manufactured with operator safety in mind. Located on the are various decals to aid in operation, and warn of caution areas. Pay close attention to all decals. DO NOT REMOVE ANY OF THESE DECALS. IF DECALS ARE LOST, DAMAGED, Top Dog OR IF THE IS REPAINTED, REPLACE DECALS.
Page 24
DECAL LOCATION 78499 (1136) 8488 78827 (1140) 1494C 1494C 1494C 54034 1494P BSSTMS20 Decal used only when a Tarp is installed 1494K 11599 1494C 1494C 1494P 1494K 11599 Decal used only when a Tarp is installed NOTE: Decals are the same on both sides BSSTMS20 -22-...
Page 25
DECAL LOCATION 78499 (1136) 8487 78827 (1140) 1494C 1494C 1494C 1494C 8040 1494C BBSTMS20 BBSTMS20 BBSTMS20 BBSTMS20 8039 84045 72203A 54034 BBSTMS20 1494C 1494P Decal used only when a Tarp is installed 1494K FEMA -23-...
TROUBLESHOOTING WARNING: MAKE SURE THE TRACTOR IS SHUT OFF AND THE TRAILER CANNOT MOVE BEFORE Top Dog SERVICING THE . MAINTENANCE AND REPAIR SERVICE WORK MUST BE PERFORMED BY A QUALIFIED SERVICE PERSON ONLY. TROUBLE CAUSE REMEDY Load will not move Truck PTO not engaged Engage truck PTO Hydraulic couplers between...
Page 32
H&S MFG. CO. products approved for the FEMA SEAL OF QUALITY Manufactured By: H&S MANUFACTURING CO., INC. 2608 S. HUME AVE. MARSHFIELD, WI 54449 (715) 387-3414 | hsmfgco.com...