How To Clean/Disinfect - ergoline JK 103/40-3 AC Operating Instructions Manual

How to use this device
54/92
12.15

How to clean/disinfect

Infections can be transferred through skin contact.
All items/equipment components, with which the user can
come into contact during tanning, must be cleaned and
disinfected after every tanning session:
– Protective goggles
– Acrylic panels
– Handles and control panel
– AUX cable
– Adjustable air nozzles
– Use only EPA registered quaternary ammonium germi-
cidal based detergent solution (follow product label for
use-dilution), such as Lucasol One Step, to clean and
disinfect the tanning system and its components.
– Other cleaning agents, especially concentrated disin-
fectants or solvents (e.g. Lysoform, ethyl alcohol or oth-
er liquids containing alcohol) must never be used for
cleaning.
NOTE:
For thorough cleaning and disinfection, the product must be
allowed to remain in contact with the surface being cleaned
and disinfected for a specified amount of time.
This specified amount of time depends on the cleaner/
disinfectant which is used. Follow the directions for use of the
cleaner/disinfectant.
After this specified application time remove remaining clean-
er/disinfectant from the surfaces of the device. Use a single-
pass paper towel.
Once the remaining cleaner/disinfectant has been removed,
perform a visual inspection for signs of any remaining clean-
ing solution, or areas still soiled. If either are remaining, re-
peat the cleaning process until a visual inspection can be
successfully completed without the need for additional clean-
ing.
If any of the components listed above cannot be successfully
cleaned and disinfected, they must be replaced.
WARNING!