Table of Contents
Advertisement
What this device is
16/92
3.8.2
Setup location
Sudden movements and malfunctions!
Crushing hazard.
–
The device is not suitable for operation in mobile facili-
ties (ships, buses, trains).
Danger of overheating by obstruction of the air routing!
Any liability is excluded in case of damage or injury proven
to be the result of the use of non-genuine spare parts.
Use of non-compliant lamps voids warranty and risks injury!
–
Do not change, obstruct or block the air inflow and
outflow area to the device or make any unauthorized
changes to the device. The manufacturer shall bear no
liability for damage or injuries resulting from such ac-
tions.
–
Observe the ventilation information to avoid serious
system malfunctions.
–
Before putting a device into operation, the transport
pallet must be removed from under the device. Danger
of overheating by obstruction of the air routing.
–
Maintain the minimum distances from the walls! Dimen-
sions are given on page 28.
–
Only use OEM spare parts of the same type! The use of
other parts will void the manufacturer's warranty!
Salty air! Contaminated air!
Device damage due to corrosion of the housing and electrical components.
–
Do not install the device near swimming pools.
–
Do not operate the device in locations with aggressive environmental
conditions (e.g. air containing chlorine).
Damage to the device possible!
Where there are great differences in temperature between the transport route
and the installation site the device may not be put into operation immediately
after being set up.
–
Wait at least 2 hours before connecting the device to the power supply.
Damage to the device possible!
The device is not to be used outdoors.
WARNING!
CAUTION!
NOTICE
Advertisement
Table of Contents
