Display Panel Functions; Quick Guide To Menu; Rapid Count - Coemar LEDko EXT + User Manual

10

. Display panel functions

10.1

Quick guide to menu

To access the functions menus just press the MENU button. Then press + or – buttons to scroll
the pages and press the ENTER button to access to any other function.
By suitably using all the functions of LEDko EXT +, which can be activated through its display
panel, it is possible to change some of the parameters and to add some functions. Changing the
preset settings made by Coemar can vary the functions of the projector so that it will respond
differently to the controller; therefore carefully read about the functions described here before
carrying out any possible selection.
10.2

Rapid count

Through the display panel of LEDko EXT + it is possible to quickly change the various numbers
displayed for the different functions in the following 3 manners:
1. Pressing the + or – buttons will cause the count to be quicker.
2. Pressing first + and then – and then holding them down simultaneously will cause the numbers
to jump to the highest value.
3. Pressing first – and then + and then holding them down simultaneously will cause the number
to jump to the lowest value.
A001
This will be the first screen that will appear on the display once
5 CH
the projector is turned on. To change the DMX address press
Auto
the "+" button and chose the DMX address desired.
N.B. If the projector is not connected to the DMX signal, A001
will blink intermittently
25