Table of Contents
Advertisement
4.3
Adjusting unit's tilt
In order to adjust the tilt of the unit simply loose the
the tilt and lock the yoke by tightening the screw again.
4.4 Optical group, framing system and gobos
Follow these steps in order to configure the optical group properly:
1. Remove the two screws "C" placed on both sides of the optical holder tube;
2. Gently remove the optical holder tube "D" pulling it away from the body;
B
C
screw "B" on the yoke, adjust
side
!Before closing the cover after each
cleaning or adjustment, remember
to heat the LEDs for at least 20
minutes, to be sure to eliminate all
traces of humidity inside and make
sure that the sheaths remain in
their seat to avoid infiltrations.
D
12
Advertisement
Table of Contents
