Configuring And Parameter Assignment; Requirements - Siemens SIMATIC ET 200AL System Manual

Configuring and parameter assignment

3.1

Requirements

Introduction
You need additional software components to use Time-based IO. You must also have
created the standard configuration for your project.
Below you will learn more about the standard configuration for Time-based IO.
Requirements
In the TIA Portal:
● The project has been created.
● The CPU has been created and the parameters are assigned.
● ET 200 distributed I/O and modules have been created and the parameters are assigned.
● The connection has been created and the parameters are assigned via PROFINET.
● A "Synchronous Cycle" OB has been created.
In addition for IO-Link:
● S7-PCT is installed on the programming device/PC.
● IODD for IO-Link device (with time stamp function) are installed.
See also
System environment (Page 17)
Configuration software requirements (Page 19)
High-precision input/output with Time-based IO
Function Manual, 08/2014, A5E33454822-AB
3
25