Siemens SIMATIC ET 200AL System Manual page 1348

Integration into the automation system
3.1 Configuration of the IO-Link system
Setting device parameters
Specific parameter settings are required to adjust the device to the respective application
task. The possible parameters and set values are contained in the IODD of each device. You
set the device parameters directly in S7-PCT.
After selecting the corresponding device in the project tree (left tree), set the device
parameters in the "Parameters" tab.
The figure below shows you an example of the parameter assignment of an IO-Link device:
Figure 3-4 Setting the parameter values of the IO-Link device
Starting from the displayed defaults, you can edit and save the values in the defined value
range.
The configuration of the IO-Link system and the parameters of the devices are available to
the IO-Link system and the entire automation project. You have the option of saving and
printing the configuration and the parameters.
24
Function Manual, 12/2017, A5E31637677-AB
IO-Link system