Table of Contents
Advertisement
rCautions when setting up the projector
f Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f When installing the projector with a method other than the floor installation using the adjustable feet or the
ceiling installation, use the four screw holes for ceiling mount (as shown in the figure) to fix the projector.
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f Use a torque screwdriver or Allen torque wrench to tighten the fixing screws to their specified tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M6, tapping depth inside the projector: 12 mm (15/32"), torque: 4 ± 0.5 N·m)
f Do not stack projectors on top of each other.
f Do not block the ventilation ports (intake and exhaust) of the projector.
f Prevent hot and cool air from the air conditioning system to blow directly to the ventilation ports (intake and
exhaust) of the projector.
500 mm (19-11/16") or longer
1 000 mm (39-3/8") or longer
f Do not install the projector in a confined space.
When installing the projector in a confined space, provide air conditioning or ventilation separately. Exhaust heat
may accumulate when the ventilation is not enough, triggering the protection circuit of the projector.
f Panasonic Connect Co., Ltd. takes no responsibility for any damage to the product caused by an inappropriate
choice of location for installing the projector, even if the warranty period of the product has not expired.
18 - ENGLISH
Chapter 1 Preparation — Precautions for use
Screw holes for ceiling mount (M6)
Adjustable feet
Positions of screw holes for ceiling mount and adjustable feet
500 mm (19-11/16") or longer
Adjustable feet
100 mm (3-15/16") or longer
Advertisement
Table of Contents
