Table of Contents
Advertisement
Chapter 5 Operations — Using the information monitor function
[SHUTTER]
[OSD]
[IP ADDRESS]
[SETUP] menu
Set the information monitor to the menu operation mode by pressing the <INFO> button on the control panel.
For the operation of the menu, refer to "Basic operation procedure in the menu operation mode" (x page 181).
[ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1)
Press as to select [SETUP].
2)
Press the <执行> button.
f The sub-menu item is displayed.
3)
Press as to select [ID].
4)
Press the <执行> button.
f Setting in [PROJECTOR ID] is displayed.
5)
Press the <执行> button.
f Setting can be changed.
6)
Press qw to switch the setting item.
f The items will switch each time you press the button.
[ALL]
[1] - [64]
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [PROJECTOR SETUP] menu → [PROJECTOR ID]
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control or computer
control.
f If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
f Refer to "Setting ID number of the remote control" (x page 70) for how to set the ID number on the remote control.
[INFO MONITOR]
Set the information monitor.
r Setting the display during normal status
Display/hide the information monitor during no operation.
1)
Press as to select [SETUP].
2)
Press the <执行> button.
f The sub-menu item is displayed.
3)
Press as to select [INFO MONITOR].
4)
Press the <执行> button.
f The detailed setting item is displayed.
5)
Press as to select [DEFAULT].
f The current setting is displayed.
6)
Press the <执行> button.
f Setting can be changed.
182 - ENGLISH
Status of the shutter ([CLOSE]: Shutter function enabled; [OPEN]: Shutter function disabled)
Status of the on-screen display function ([ON]: Display; [OFF]: Hide)
IP address of the wired LAN
Select this item when controlling projectors without specifying an ID number.
Select this item when specifying an ID number to control individual projector.
Advertisement
Table of Contents
