Table of Contents
Advertisement
Note
f Lens memory with numeric value information of the periphery focus position displayed is the lens memory saved when one of the following
lenses is attached.
g ET-EMW200, ET-EMW300, ET-EMW400, ET-EMW500
[LENS HOME POSITION]
Operate in following procedure to move the projection lens to the home position.
1)
Press as to select [LENS].
2)
Press the <执行> button.
f The [LENS] screen is displayed.
3)
Press as to select [LENS HOME POSITION].
4)
Press the <执行> button.
f The confirmation screen is displayed.
5)
Press qw to select [OK], and press the <执行> button.
f The projection lens is moved to the home position.
Note
f [PROGRESS] is displayed in the menu while the projection lens is moved to the home position.
f [---] is displayed in the confirmation screen for execution of the lens home position in following cases.
g When the automatic acquiring of the projection lens information has failed
f The projection lens is not moved to the correct home position when the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION]
is not executed.
f If the projection lens was replaced, execute the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION].
f The home position does not match with the optical image center position.
f The home position varies depending on the projection lens type. Refer to "Lens shift range" (x page 67) for details.
f [LENS HOME POSITION] can also be executed by pressing the <默认> button on the remote control while the lens shift adjustment screen
is displayed.
[LENS CALIBRATION]
Detect the lens adjustment limit value, and perform the calibration in the adjustment range.
Execute the lens calibration after attaching the projection lens.
1)
Press qw to select [LENS].
2)
Press the <执行> button.
f The [LENS] screen is displayed.
3)
Press as to select [LENS CALIBRATION].
4)
Press the <执行> button.
f The confirmation screen is displayed.
5)
Press qw to select [OK], and press the <执行> button.
f The lens calibration is started.
f After completing the calibration, the projection lens will move to the home position.
f To cancel, select [CANCEL].
Note
f If the projection lens was replaced, execute the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION].
f [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f [INCOMPLETE] is displayed when the lens calibration is not performed correctly.
f [---] is displayed in the confirmation screen for execution of the lens calibration in following cases.
g When the automatic acquiring of the projection lens information has failed
f If the lens calibration is executed while the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] → [ACTIVE FOCUS]
is set to [ON], the operation of the temperature detection correction of the active focus optimizer function will stop.
f The origin position of the lens mounter and the home position of the projection lens are automatically updated when the lens calibration is
performed.
The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the calibration result. It
does not match with the optical image center position.
f The home position varies depending on the projection lens type. Refer to "Lens shift range" (x page 67) for details.
Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 123
Advertisement
Table of Contents
