Page 1
PT-LB1 P ro d u c t N u m b e r : LCD Projector P ro d u c t N a m e : As of July 2010. Specifications subject to change without notice. 1 / 1 0...
PT-LB1 LCD Projector Specifications Power supply 100–240 V AC, 50/60 Hz Power consumption 300 W (approx. 0.4 W with standby mode set to ECO* . 15 W with standby mode set to NORMAL. 18 W in normal standby mode when set to audio monitor out and with fan stopped.)
PT-LB1 LCD Projector Dimensions (W × H × D) 307 × 69 × 210 mm (12-3/32˝ × 2-23/32˝ × 8-9/32˝)* Weight Approx. 2.3 kg (5.1 lbs.)* Operating environment Temperature 0°– 40°C (32°–104°F)* Humidity 20%–80% (no condensation) Remote control unit Power supply 3 V DC (R03/AAA type battery ×...
PT-LB1 LCD Projector Dimensions unit : mm (inch) NOTE: This illustration is not drawn to scale. ( 3-1/8 ) (7-1/16 ) 307 (12-3/32) Terminals 1 LAN connector 2 Serial input 3 Computer 1 input 4 S-Video input 5 Audio output...
PT-LB1 LCD Projector Standard setting-up positions unit : mm (inch) ø49 (1-15/16) ø42 Upper edge of projected image (1-11/16) L: Distance to screen H: Height from the edge of screen to center of lens Projected image (3-15/16) Lower edge of projected image...
Page 6
PT-LB1 LCD Projector Computer data compatibility This projector accepts up to 91 kHz horizontal scanning frequency and 193 MHz dot clock. NOTE: Pixel thinning is applied to signals that exceed a dot clock frequency of 110 MHz. The display resolution of this projector is 1,024 × 768 pixels.
Page 7
PT-LB1 LCD Projector Serial connector The serial connector complies with RS-232C. To control the projector from a personal computer, com- mands must be input through communication software, based on the format and satisfying the commu- nication conditions shown below. Pin assignments and signal names...
PT-LB1 LCD Projector Control commands Command: <Parameter> Function Callback: <Parameter> Parameter value Power on (standby mode on) PO N – – Power off (standby mode off) PO F – – Volume control AV L:< pl > AV L:< pl >...
Page 9
PT-LB1 LCD Projector Status asking commands Command Description Callback <Parameter> Q P W Standby power status <power condition> Q $ S <lamp condition> Lamp status Q I N <input signal> Input signal status Q A V <pl> Volume adjustment value...
Page 10
PT-LB1 LCD Projector Notes on projector placement and operation The projector uses a high-wattage lamp that becomes very hot during operation. Please observe the following precautions. Never place objects on top of the projector while it is operating. Make sure there is an unobstructed space of 500 mm (19-11/16˝) or more around the projector’s exhaust openings.