Table of Contents
Advertisement
Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
Removing and Replacing the Case Group Parts
Tools Required
• T-8 TORX driver (set to 6 in-lb)
• T-10 TORX driver (set to 9 in-lb)
• Isopropyl alcohol (Use only in a well ventilated area.)
•
Repair and Re-assembly
Before beginning any repair, disconnect the power cord.
WARNING
Replacing the Kickstand, Hinge Cover, and Hinge
1. Remove, and discard, the four screws (item 1) from the kickstand hinge cover. New
screws are provided in the
Figure 7-2
Replacing the Kickstand and Hinge Cover
7-6
Kit. Refer to
"Miscellaneous Parts" on page
Repair and Re-assembly
RF Vector Network Analyzer
6-12.
Kit.
Service Guide N9923-90005
N9923AN
Advertisement
Table of Contents
Troubleshooting
