Agilent Technologies FieldFox N9923AN Service Manual page 86

Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
Separating the Front and Rear Cases
1. Remove the battery. Refer to
2. Loosen the six screws (item 3) that secure the RF top panel. It should not be necessary
to remove these screws, just loosen them.
3. Remove, and discard, the six screws (item 4) that secure the rear case to the front case.
New screws are provided in the
Figure 7-4 Separating the Front and Rear Cases (1)
7-8
"Removing and Replacing the Main Battery" on page
Repair and Re-assembly
RF Vector Network Analyzer
Kit.
Service Guide N9923-90005
N9923AN
7-5.