Agilent Technologies FieldFox N9923AN Service Manual page 85

RF Vector Network Analyzer
N9923AN
2. To replace the entire kickstand assembly:
a. Lift the kickstand assembly off of the rear case and discard it.
b. Place the new kickstand assembly on the rear case.
c. Place the new hinge cover in position and secure it with four new screws. A new
hinge cover and new screws are provided in the
3. To replace the hinge cover:
a. Position the new hinge cover in place and install four new screws. New screws are
provided in the
4. To replace the hinge:
a. Lift the kickstand assembly off of the rear case.
b. Remove and discard the four hinge attachment screws (item 2).
c. Place the new hinge in position and install with four new screws. New screws are
provided in the
d. Place the kickstand assembly in place on the rear case and reinstall the hinge cover
with new screws provided in the
Figure 7-3 Replacing the Hinge
Service Guide N9923-90005
Repair and Re-assembly
Repair and Re-assembly
Repair and Re-assembly
Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
Repair and Re-assembly
Kit.
Kit.
Kit.
Kit.
7-7