Ratings Compatibility; Pre Installation Configuration - DSC neo TL280E Installation Manual

Cellular alarm communicator, internet and hspa dual-path alarm communicator, internet alarm communicator
Table of Contents

Advertisement

Model
Power Supply Ratings
Input Voltage
Current Consumption
Standby Current
Alarm (Transmitting)
Current
Operating Frequency
Typical Antenna Gain
Environmental Specifications
Operating Temperature
Humidity
Mechanical Specifications
Board Dimensions (mm)
Weight (grams) with
bracket
Communicator Receiver/Panel
3G2080(R)E
Receiver
TL2803G(R)E Panel
NOTE: Enter [*][8][Installer Code][900] at keypad to view the panel version number.
Encryption
The communicator uses 128 Bit AES encryption. Encryption can only be enabled from the monitoring station receiver. Each
receiver (Ethernet 1 and 2, cellular 1 and 2) can independently have encryption enabled or disabled. When encryption is
enabled, the central station will configure the device to encrypt communications the next time the communicator module per-
forms a communication to that receiver.
NOTE: Packets will start being encrypted only after the next event is sent to that receiver, or if the unit is restarted.
Before leaving the installation site, the communicator TL2803G(R)E Ethernet line shall be connected via an APPROVED
(acceptable to the local authorities) Network Interface Device (NID). All wiring shall be performed according to the local
electrical codes.

Ratings Compatibility

Table 1: Communicator Ratings
3G2080(R)E
Cellular only
Power is supplied from the panel's PC-Link header or a PCL-422 module in remote cabinet
installations. In remote cabinet installations, the PCL-422 module located with the communicator is
powered by either an HSM2204 or an HSM2300. Refer to the PCL-422 installation instructions for
90mA @ 13.66V
Depends on model (refer to Model Information on page 3)
100 × 150 × 15
310
Table 2: Compatible Receivers and Panels
Sur-Gard System I-IP Receiver, version 1.13+
l
Sur-Gard System II Receiver, version 2.10+
l
Sur-Gard SG-DRL3-IP, version 2.30+ (for Sur-Gard System III Receiver)
l
Sur-Gard SG-DRL4-IP version 1.20+ (for Sur-Gard System IV Receiver)
l
Sur-Gard SG-DRL5-IP version 1.00+ (for Sur-Gard System 5 Receiver)
l
HS2016
l
HS2016-4
l
HS2032
l
HS2064
l
HS2128
l

Pre Installation Configuration

TL280(R)E
Internet only
10.8-12.5 VDC
details.
400mA @ 12V
2dBi
-10°C to 55°C
5% ~ 93% relative humidity, non-condensing
Description
5
TL2803G(R)E
Internet and Cellular
120mA @ 13.66V
100 × 150 × 15
320

Advertisement

Table of Contents
loading

Table of Contents