Table of Contents
Advertisement
5. Remove the two (M1.6x1.7) screws that secure the smart-card reader in place.
6. Lift and remove the smart-card reader with the smart-card reader FFC from the chassis.
Installing the smart-card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
CAUTION:
The information in this installation section is intended for authorized service technicians only.
NOTE:
The following procedure is applicable for systems shipped with a smart-card reader only.
The following image indicates the location of the smart-card reader and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
75
Advertisement
Table of Contents
