Table of Contents
Advertisement
2. Install the
SD
card.
3. Follow the procedure in
System fan
Removing the left fan
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
CAUTION:
The information in this removal section is intended for authorized service technicians only.
The following images indicate the location of the left fan and provide a visual representation of the removal procedure.
Steps
1. Disconnect the left-fan cable from the connector on the system board.
2. Remove the two (M2x4) screws that secure the left fan to the palm-rest assembly.
3. Lift the left fan from the outside and remove it from the palm-rest assembly.
Installing the left fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
56
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.
Before working inside your
Advertisement
Table of Contents
