Dell M5680 Owner's Manual page 125

Table 35. System setup options—Storage menu
Storage
SATA Operation
Storage Interface
Drive Information
Enable SMART Reporting
Enable MediaCard
Secure Digital (SD) Card Read-Only Mode Enable or disable the SD card read-only mode.
Table 36. System setup options—Display menu
Display
Display Brightness
Brightness on battery power
Brightness on AC power
Touch Screen
Full Screen Logo
Table 37. System setup options—Connection menu
Connection
Wireless Device Enable
Enable UEFI Network Stack
Enable UEFI Network Stack
Wireless Radio Control
Control WLAN radio
124 BIOS Setup
Configures operating mode of the integrated SATA hard drive controller.
Default: RAID On. SATA is configured to support RAID (Intel Rapid Restore
Technology).
Displays the storage interface.
Displays the information of various onboard drives.
Enables or disables Self-Monitoring, Analysis, and Reporting Technology
(SMART).
Default: OFF
Enables to switch all media cards On/Off or set the media card to read-only
state.
By default, Enable Secure Digital (SD) Card is selected.
By default, the Secure Digital (SD) Card Read-Only Mode option is not
enabled.
Sets the screen brightness when the computer is running on battery power.
Default: 50
Sets the screen brightness when the computer is running on AC power.
Default: 100
Enables or disables the touch screen for the OS.
NOTE: The touch screen will always work in the BIOS setup irrespective of
this setting.
Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
Enable or disable internal WLAN/Bluetooth devices.
By default, WLAN is selected.
By default, Bluetooth is selected.
When enabled, UEFI networking protocols are installed and available, allowing
pre-OS and early OS networking features to use any enabled NICs. This may be
used without PXE turned on.
Default: ON
Enables to sense the connection of the computer to a wired network and
subsequently disable the selected wireless radios (WLAN and/or WWAN).