Table of Contents
Advertisement
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
SD
card.
3. Remove the
base
cover.
About this task
CAUTION:
The information in this removal section is intended for authorized service technicians only.
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
NOTE:
The following procedure is applicable for models shipped with an M.2 2280 solid-state drive in the SSD1 and/or
SSD2 slot.
Steps
1. Remove the single (M2x2) screw that secures the solid-state drive thermal plate in place.
2. Remove the solid-state drive thermal plate from the system board.
3. Remove the M.2 2230 solid-state drive from the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
CAUTION:
The information in this installation section is intended for authorized service technicians only.
48
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
computer.
Before working inside your
Advertisement
Table of Contents
